|
 |
||||
Earlier this week I went out to the hangar and ran some strips of fiberglass over the outside and inside of the plenum intakes. This is what it looked like tonight when I arrived at the hangar. I sanded it down and then reinstalled the rings. I could tell as I tightened down on the hose clamps this thing was much stronger now.  Finally tonight I put some velcro on the bottom of the foam inserts I made for the floor. They seemed to stick really well to the floor!  Also tonight I installed the center section and fuel pump covers. These weren't any fun to install. They just didn't fit very well together. Oh well. I dont have to worry about this until the next annual! 
|
|||||
|
http://RVplane.com |
Last Modified: October 5, 2024 |