[<<Prev]
[Next>>]
[October 20, 2009]


Well I finally did it. I figured out the right process to get the dry transfer labels to work. I got to tell you these look absolutely perfect. I am very pleased with how they turned out. You can see I used some light-tack painters tape on the bottom of the switch/CB/Pot holes to act to align the transfers. On the bottom of the label transfers there are alignment marks that I put right over the tape. Once they are lined up, I press upwards the rest of the label. That way I know for sure my alignment is perfect.


I was just going to do one set of labels tonight, but I was so pleased with the top row I just needed to continue down. This label was slightly more complex and it came out perfect as well. So far they are taking about 40 minutes per set to prepare and apply. Hopefully tomorrow I will be able to finish the rest of the panel.

[<<Prev]
[Next>>]

http://RVplane.com

Last Modified: September 4, 2017