[<<Prev][Next>>]
[December 19, 2007]


Continued off from yesterday and finished up drilling and trimming these small angles. Fun fun fun.


Next was onto the angle that goes behind the panel. This needed to be cut to length, then marked with a million lines to indicate where 15 degree slots get cut so the angle can contour to the curvature of the top of the panel. I drilled some pilot holes with a #30 drill on the drill press (with a fence set up) to mark the vertex of the slots.

[<<Prev][Next>>]

http://RVplane.com

Last Modified: November 11, 2017